Xiamen Nuoger New Materials Co., Ltd. is a production-oriented enterprise specializing in precision die-cutting and new material processing. We have a large number of advanced production equipment and calibration equipment, a 1500-square-meter ten-thousand-class clean worksho...
The waste removal technology for small holes in 0.6mm thin films (especially for polytetrafluoroethylene, PTFE materials) has significant advantages in industrial filtration and separation processes. Its core value is reflected in aspects such as high - efficiency filtration, energy conservation and consumption reduction, and process adaptability.
The accuracy of ordinary die - cutting machines is usually above ±0.1 mm.
tolerance
The stamping and die - cutting of 0.6 mm thin film can achieve a cutting accuracy of **±0.02 mm.
Ordinary die - cutting with 52° knives is likely to squeeze the material and cause burrs.
flatness
Die-cutting with a 0.6 mm die can avoid the problems of flanging and burrs caused by the toughness of the film.
Ordinary die - cutting is prone to the breakage of the release paper and label dropping for films with a thickness of ≤0.1 mm
Adapt
The thickness tolerance of the 0.6 mm thin film is extremely small (the thinning range ≤ 0.01 mm)
Ordinary devices rely on manual debugging, which is inefficient and has a high failure rate.
Intelligent
The 0.6mm die-cutting PLC touch control system can store 300 groups of parameters, automatically adjust the speed and pressure, and is equipped with infrared photoelectric protection to ensure continuous production in a clean room environment (with a speed of up to 35 times per minute).
Ordinary slitting machines are limited to ≤5,000 meters and have insufficient accuracy. The edge flatness is ±0.05 mm.
capacity
The 0.6mm die-cutting supports slitting of ultra-long rolls up to 10,000 meters (such as 0.6 mm×10,000 m tape), and the edge flatness reaches ±0.05 mm.
The cost of ordinary die - cutting materials is high. Manual waste removal cannot control the accuracy, and it is easy to waste materials.
waste
The 0.6mm die - cut double - cut film areas share one edge. Two products are formed in one stamping, reducing the waste of connecting edges and increasing the material utilization rate by 15% - 20%.